NEW Original Type High Quality AV7 AV10 Engine Bottom End Crankshaft with conrod for Raleigh Mopeds

Bottom End Crankshaft for the Original AV7 and AV10 Engines fitted to The Raleigh Mopeds with left hand thread magneto.

High quality crankshaft made in europe

To replace Raleigh part number MTA269 fitted to engine numbers after R.100101.

Note the mag side length is longer than the original so the mag nut should be replaced with the new hexagonal type that we do MMN227R.

Clutch side length 8 cm crank to end (same as original)

Mag side length 6.2 cm crank to shoulder (original was 

Mag side length crank to end 8 cm overall (original Raleigh was 7.1 - 7.3 cm)

This is a special item so only limited stock is available. If out of stock please contact us.

This has been checked against the original Bottom Ends as suitable with the following parts (need to be purchased separately):-

-              16mm crankshaft bearing and seals

-              Clutch Nut Raleigh part MMN166

-              Left hand thread hexagonal magneto nut replacement Raleigh part MMN227R (note not the original)

Suitable for the following models:-

- Raleigh RM4 Automatic

- Raleigh RM6 Runabout

- Raleigh RM7 Wisp

- Raleigh RM8 Automatic II

- Raleigh RM9 Ultramatic